LC-1 programmer issues??
 

Every time i go in to try to change "analog out 1" voltage curve which is hooked to narrow band signal to the ecu and when i change the numbers and press "program" tab nothing happens, it just stops right there and the program tabs stays pushed on the screen.
I have the KOEO
I have the computer hooked to the serial OUT of the LC-1
I have the terminator in the IN

I don't know if i have a computer issue or a LC1 issue or maybe it is changing the settings but i really have no clue.

Please help

2000 civic si
b16a2
afc for now with stock ecu p2t
t3 netics


thanks

Re: LC-1 programmer issues??
 

Close it and go back to the tab. Are the values the ones that you just inputted? I had the same issue, I think that it just works that way. When I went back to the tab, the values i wanted were there.

Re: LC-1 programmer issues??
 

I will try hopefully late tonight, i know the last time i went back in to check it and it showed the factory settings, but then again it may have been something i did wrong.

Thank you!!

Re: LC-1 programmer issues??
 

I don't think this has much to do with it, but this time i went ahead and renamed the Lc-1 and it took all the changes. It seems to work good now, crap the other night it got so screwed up and read extream lean to rich and i had to pull the sensor back out so i could recalibrate it like 40 miles from my house in the wal-fart parking lot. :S :6