LC-1 with OBD0
Got the LC-1 cable, was reading up on the net about a portable installation solution using the jack plug for cig lighter...etc etc It is a OBD0 mpfi ecu.
However my question is that for the System Ground and Analoug Ground do twist them together and tap into A16/A18? And for the Analouge Output 1 , do I cut C16 and connect there? (so I can join the wire back up once I am not using wideband). I am planning to datalog with ECU control do I have to scale the voltage for the signal output from LC1 ? If so any info on that? |
Re: LC-1 with OBD0
Be sure your cigarette socket has enough voltage/amperage, otherwise it work work!
|
Re: LC-1 with OBD0
Hi,
What is the minimum required Amp/Voltage? Thanks |
Re: LC-1 with OBD0
It runs fine off the cig lighter. I ran mine off it and so do all of my friends.
|
Re: LC-1 with OBD0
Analog outpu 1 is allready factory scalled to simulate NB you can attach where stock sensor was connected to ECU
|
Re: LC-1 with OBD0
Analog 2 is configred for Wideband output voltage as well.
I personally wouldnt recommend hooking up to your cig lighter. There are many other accesories off that circuit that can affect what your wideband reads. I use a 12v source from the ECU harness...I think it is the O2 heater 12v if I remember correctly. |
All times are GMT -5. The time now is 01:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands