Installing vafc on obd0 pr3 tomorrow - is this right?
#1
Installing vafc on obd0 pr3 tomorrow - is this right?
Well I think I've got all except 2 wires right, what do you guys think? (I have searched here and honda-tech, just double-checking).
Purple (vtec solenoid) = A8
Pink (vtec solenoid) = A8
Yellow (vtec pressure switch) = B5
White (vtec pressure switch) = B5
Gray (Throttle signal) = C7
Black (ground) = A16
Brown (ground) = A16
Red (IG power) = A13
Orange (IG power) = A13
Now the 2 I'm not sure of are Blue (VTM signal) and green (RPM signal). I've read that green goes to the distributor ground, is that correct and if so, what # is it? Blue I have no clue where it goes, do I even need it or have a VTM signal? Thanks a ton guys.
Dan
Purple (vtec solenoid) = A8
Pink (vtec solenoid) = A8
Yellow (vtec pressure switch) = B5
White (vtec pressure switch) = B5
Gray (Throttle signal) = C7
Black (ground) = A16
Brown (ground) = A16
Red (IG power) = A13
Orange (IG power) = A13
Now the 2 I'm not sure of are Blue (VTM signal) and green (RPM signal). I've read that green goes to the distributor ground, is that correct and if so, what # is it? Blue I have no clue where it goes, do I even need it or have a VTM signal? Thanks a ton guys.
Dan
#2
Re:Installing vafc on obd0 pr3 tomorrow - is this right?
Also, I will be turbo in the next month or 2 but want to get this installed and out of the way now. If I just hook this thing up what settings should I put in so that it runs pretty much like it is now? ie: I don't wanna change anything, just have it installed and out of the way.
thanks again!
thanks again!
Thread
Thread Starter
Forum
Replies
Last Post
Slo_crx1
Engine Management
4
03-18-2007 06:40 PM
staticchmbr
General Discussion
5
05-01-2006 10:36 AM
robs99si
Engine Management
9
06-08-2004 10:28 PM