installed my chipped p28 and 450s - now car barely runs
put my chipped ecu in with my boomslang harness, put my 450s in, crossed my fingers and started it up, it sounds like it wants to start but doesnt, it just kinda chugs and quits or doesnt even fire..
where should i start? im gona go out with a multimeter and check the injectors and resistors. anyhelp would be great. note to self: dont turbo a car without a spare car. |
Re: installed my chipped p28 and 450s - now car barely runs
resistance at all injectors was 2.2-2.5
resistance at the injector plugs was al about 71 |
Re: installed my chipped p28 and 450s - now car barely runs
did you change injector size in program from 240->450?
|
Re: installed my chipped p28 and 450s - now car barely runs
how do i do that? do i need a chip burner? dammit. dude i got it from said it should run my car with my set up untill i can get it tuned. i have a data logging cable and a laptop, and uberdata 1.6 and 1.7 but i havent used em yet.
|
Re: installed my chipped p28 and 450s - now car barely runs
well yeah you have to have a burner. just have the guy that you got it from reburn an change injector sizing to 450 CC
|
Re: installed my chipped p28 and 450s - now car barely runs
if the injectors seem fine than you'd have to check the ecu/chip but too bad you don't have a chip burner :P
|
Re: installed my chipped p28 and 450s - now car barely runs
do you get a constiant check engine when the jumper is done
|
Re: installed my chipped p28 and 450s - now car barely runs
i dont get any check engine light, i havent done the jumper tho
|
Re: installed my chipped p28 and 450s - now car barely runs
no check engine light ecu/eprom are good
|
Re: installed my chipped p28 and 450s - now car barely runs
Originally Posted by chris
no check engine light ecu/eprom are good
|
All times are GMT -5. The time now is 09:33 AM. |
© 2024 MH Sub I, LLC dba Internet Brands