installed 450 dsm's, but i have a problem!
 

I started installing my 450cc blue tops, but I have a problem. I bored out my factory seals, and then I installed the injectors. I tightened the fuel rail and now the seals stick out of the manifold a little tiny bit and the injectors aren't tight enough because I can turn them with a little bit of force.. is this normal?

Also, I dropped one of my injectors and cracked the black plastic piece over the end of it in a couple spots, I super glued it back together, but I'm worried about it. Should I get a new injector or will it be fine?

Stan

Re:installed 450 dsm's, but i have a problem!
 

Normal ----. You shouldn't have any problems.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

Re:installed 450 dsm's, but i have a problem!
 

If the plastic protector is broke, take it off, you dont need it unless you are clumsy an drop ---- all the time its just a protector

Re:installed 450 dsm's, but i have a problem!
 

Are you sure it's just a protector? I thought maybe it changed the way the injector sprays or something? It doesn't seem to clip off, do I have to break it to get it off?

Stan

Re:installed 450 dsm's, but i have a problem!
 

yes they are just protectors but once you take the plastic bit off dont drop it, i got 2 missing on my setup and you can bet 90% of the people on here running 450's have the same problem. I prized mine off with sidecutters but whatever floats yer boat, better it coming off now than in yer engine

Re:installed 450 dsm's, but i have a problem!
 

Yeah stan you'll be fine without those caps. Mine had them all but I got lucky ;) And as far as your factory seals go, mine were a little loose too so i could spin them in the seal, but I have no leaks. Just check carefully for any leaks before you go and call it a day. I seriously spent a whole day making damned sure I wasn't pissing any gas after my injector install. But all tuned out fine ;)