KAOS

ok i have my B18b swap in w/ my P72 ecu that i chipped using Uberdata 1.70. i import'd the P75 .bin and disabled all the vtec things(or atleast i think i did!!). and i disabled o2 sensor, closed loop, ELD, and speed limiter(just in case there was one.)

i am throwing code 21(it has to do with vtec. but i don't have my manual in front of me to list what it is exactly.). and obviously i don't have vtec w/ my B18b.

so my question is:

since i have the closed loop disabled. does it even matter that i'm throwing that code?
(since my ecu should run like there isn't a code being thrown. since i disabled the closed loop. or i could very well be misunderstanding all this )


i post'd this on Uberdata's forum but for reason anyone that knows what there doing on there is NEVER on there!!! i did post my .bin on there. so anyone could look at it to see if i DID disable all the vtec things!! my username is "KAOS" on Uberdata aswell. i post'd it in the 'newbie Q/A'.

thanks

Chris Harris

Did you disable VTP?

I'd sell that chipped P72 for some loot and get yourself a cheapo P05 ECU, chip that and run your LS motor with that. You;d come out way ahead.

My $.02

KAOS

no i did not disable the VTP. i wasn't sure if i had too or not. and i just figured out like 2 mins. before i read your post. that i do need to disable it!!

thanks

the reason why i'm using a P72 is 'cuz i had my B18C in my crx until my rings went. and this B18b is just a "filler" engine until i get my B18c up and running. or go ls/vtec!!