I need help
#1
I need help
Alright, got around to istalling my new chipped ecu and DSM 450s today. The problem however, is the car will not start now. It turns and seems like it wants to start but it doesnt. Ive got the resistors wired into the yellow wire with the black stripe like the tech artical says too. The car isnt throwing a CEL when i go to start it. Im fairly confident the injecters are in working order as the car started before, but ran awfull and threw a CEL due to the basemap having the car looking for a knock sensor. After changing the basemap to eliminate the knock sensor the car no longer started. Any help would be greatly appreaciated as this is my only means of transportation.
#2
Re: I need help
ok problem is solved, after letting the car set for a while i came back out and tryed it again, started right up and after letting it run for a few minutes the car idles perfectly at about 14.6 to 14.8. It runs well, i still have to drop the stock cat and check my wastegate and i should be good to go for full boost.
Thread
Thread Starter
Forum
Replies
Last Post
sohcpwr
Forced Induction
10
08-26-2005 06:55 PM