How to install filter mounted fuel pressure gauge
 

This is permanantly hosted on my site at:
www.lukekailburn.com

How to install a fuel filter mounted Fuel pressure Gauge

The parts
-Teflon wrap the guage threads, and the male threads on the 90* fitting. thats it!
http://www.lukekailburn.com/media/en...e/100_2785.jpg

Unscrew your gas cap to relieve some of the fuel pressure
http://www.lukekailburn.com/media/en...e/100_2782.jpg

Wrap the banjo bolt with some shop rags and remove the 12mm bango bolt.
http://www.lukekailburn.com/media/en...e/100_2783.jpg

Stock bango bolt removed. Clean the surfaces of any debris.
http://www.lukekailburn.com/media/en...e/100_2787.jpg

Install the new banjo bolt with new crush washers
http://www.lukekailburn.com/media/en...e/100_2794.jpg

Install the 1/8" 90 fitting. Then install the fuel pressure gauge
http://www.lukekailburn.com/media/en...e/100_2795.jpg


An overall shot of the setup
http://www.lukekailburn.com/media/en...e/100_2796.jpg

Check your fuel pressure at idle with the fpr vacuum hose connected, then check it with the fpr vacuum hose disconnected.



congrats you have successfully installed a fuel filter mounted fuel pressure regulator.


enjoy,

-Luke

Re: How to install filter mounted fuel pressure gauge
 

I don`t think the 92 to 95 civic filter can clear with that little elbow.