helo MSD 5 question request ASAP
#1
helo MSD 5 question request ASAP
hey guys i got a MSD 5 today offof my friend, and im on MSD igniton.com and i got the wiring instructions on Adobe reader and im looking at them now. i under stand them, but where does the ***** wire go to??
GENERAL FOREIGN CAR
The following schematic is very
general to import vehicles. Some
systems may look different,
however they function in basically
the same manner. The MSD 5 can
only be installed on inductive
style ignitions. If you do not know
if your vehicle is an inductive
discharge design, connect a test
light to ground, turn the key to the
ON position and check for power
at the coil positive terminal. DO
NOT START THE ENGINE. If
there is power, it is an inductive
ignition. If there is no power on
the terminal it is capacitive
discharge and the MSD 5 cannot
be installed.
Note: Most foreign vehicles with fuel injection will require a Tach Adaptor, PN 8910.
See page 4 for details.
IM me on AOL IM ASAP my screen name is hondalowlow
im gonnahook this up tomrow morning and i need to know were that white wire goes.. ill be pissed if i burn up the MSD5.
GENERAL FOREIGN CAR
The following schematic is very
general to import vehicles. Some
systems may look different,
however they function in basically
the same manner. The MSD 5 can
only be installed on inductive
style ignitions. If you do not know
if your vehicle is an inductive
discharge design, connect a test
light to ground, turn the key to the
ON position and check for power
at the coil positive terminal. DO
NOT START THE ENGINE. If
there is power, it is an inductive
ignition. If there is no power on
the terminal it is capacitive
discharge and the MSD 5 cannot
be installed.
Note: Most foreign vehicles with fuel injection will require a Tach Adaptor, PN 8910.
See page 4 for details.
IM me on AOL IM ASAP my screen name is hondalowlow
im gonnahook this up tomrow morning and i need to know were that white wire goes.. ill be pissed if i burn up the MSD5.
#2
Re:helo MSD 5 question request ASAP
u r 2 remove the coil wires from coil install the thin red to coil power and thin white to coil ground these go to the wires then the thin orange goes in place of the coil pos. and the black goes in place of the coil ground hopes this helps good luck dark .......
Thread
Thread Starter
Forum
Replies
Last Post
BUCKETHEAD
Turbo Parts For Sale
1
08-23-2005 03:14 PM
typer
Turbo Parts For Sale
2
07-06-2004 12:54 AM