H23a1 TURBO w/ Hondata
#1
H23a1 TURBO w/ Hondata
Hey guys, Well i've been searching and it seems like a lot of you guys on here are either using uberdata, chrome, or some other engine management other than Hondata. I've considered using Hondata for my setup and was wondering if anyone here also using Hondata can help me out. My setup is:
H23a1 stock motor
Hondata s200b w/ p75 socketed
T3/T04 Turbonetics turbo
Tial Wastegate (5.28 psi)
450cc DSM injectors
255 Walbro fuel pump
and everything else to complete a turbo kit...
I want to drive it to the shop and have them tune it, but the guy at the shop said to make sure that i have it running and make sure that there's no leaks, or ignition problems before bringing it in. My problem is that I'm afraid that after i install everything, my engine will be FLOODED with fuel from the 450's and the 255 pump. He also said that i can temporarily fixed that by installing the Hondata and installing a base map for the 450's and I should be fine to drive it to the shop to be tuned. Is anyone able to help me here? I'm new to this and have not idea how to work with Hondata.
H23a1 stock motor
Hondata s200b w/ p75 socketed
T3/T04 Turbonetics turbo
Tial Wastegate (5.28 psi)
450cc DSM injectors
255 Walbro fuel pump
and everything else to complete a turbo kit...
I want to drive it to the shop and have them tune it, but the guy at the shop said to make sure that i have it running and make sure that there's no leaks, or ignition problems before bringing it in. My problem is that I'm afraid that after i install everything, my engine will be FLOODED with fuel from the 450's and the 255 pump. He also said that i can temporarily fixed that by installing the Hondata and installing a base map for the 450's and I should be fine to drive it to the shop to be tuned. Is anyone able to help me here? I'm new to this and have not idea how to work with Hondata.
Thread
Thread Starter
Forum
Replies
Last Post
VTECWITHBOOST
Engine Management
4
01-27-2004 04:39 PM