ECU chipping how-to
04-29-2007, 08:04 PM
#1
1.0 BAR
Thread Starter
Join Date: Jun 2006
Posts: 383
ECU chipping how-to
I went to PGMFI and it seems to be down. I searched through here and couldnt find anything, but I need instructions on chipping a jdm obd0 pr3. I bought the kit from xenocron and there is a TV repair shop in town that doe sit, but I need instructions.
04-29-2007, 10:42 PM
#2
3.0 BAR
Join Date: Jun 2006
Posts: 3,256
05-10-2007, 10:15 PM
#3
1.0 BAR
Thread Starter
Join Date: Jun 2006
Posts: 383
Re: ECU chipping how-to
so this is my situation. My ecu is already "chipped"(rev limiter removed) but it was soldered directly to the board. Now other than soldering the ZIF socket in, do I need to do anything else? I also have a datalogging cable I need to get working too. I will paypal someone 5 bucks if they wanna give me a write up.
05-10-2007, 10:34 PM
#4
3.0 BAR
Join Date: Sep 2004
Posts: 1,588
Re: ECU chipping how-to
http://web.archive.org/web/200506070...0_ECU_Chipping
http://web.archive.org/web/200504160...pingAn88-89ECU
If it was already 'chipped' then it seems you simply remove the existing chip and add your own. All the components to support the chip should already be there.
how's that for the write-up?
http://web.archive.org/web/200504160...pingAn88-89ECU
If it was already 'chipped' then it seems you simply remove the existing chip and add your own. All the components to support the chip should already be there.
how's that for the write-up?
Thread
Thread Starter
Forum
Replies
Last Post
Nismo-san
Engine Management
3
09-23-2007 11:55 PM
crxracer7
General Discussion
0
01-16-2006 03:20 AM
