BoostedBSeries

ok, i just picked up a 94 GSR with a USDM ITR motor in it. car runs pretty good, but vtec doesnt seem to feel right, and i dont know if it has a rev limit. well obviously it had a chipped ecu in it front some "erics racing" with a phone number on it. im sure its just some bullshit type ebay chip. anways, my problem is that "erics racing" removed all the stamps from my ECU telling what it is (p72/p28/p06, ect.). i want to put a crome pro ITR map on it with launch control, and lowered vtec engagement, does it matter what ecu i have? and will any of you guys send me a chip with what i need on it? i know this is a noob question, but i just kinda need to know asap. i dont wanna do damage to this expensive motor with a crappy chip.

turbohf

as long as it looks like the auto or manual side, you will be fine. put your CROME chip in...

i was running a ITR motor on a P05 CX ECU...it just needs to be chipped right

BoostedBSeries

SWEET. problem is, i need to GET a crome chip. do you still have the .bin you were running dustin? what mods did you have? i just want something to make the car run RIGHT. could you burn a chip for me?

turbohf

i bet you have my tune on your computer lol...

stockP72.bin... minus some fuel off after about 7500rpms (went deep into the 12's AF) and added a little in the mid range. VTEC crackin at 5800 i think...redline at 8500-8700 i dont remember.

as for the accual tune...i reformated my PC cuz it was fucked...so its gone...

BoostedBSeries

gay. ill ask chris (xeno) of he'll burn me one. do you know anywhere where i can find a stock P73 .bin?

Chris Harris

Stock OBD2 ITR Bin can be had on the PGMFI Wiki in the ROM Dump area.

Crome can open this said OBD2 file too

Replied to your PM Brett, should hopefully be up in your area next week tuning too

turbohf

you serious? ----... it will be the new "Everett stunna" tune then....lol

BoostedBSeries

i ::heart:: chris harris