Datalogging problem
 

I have an crome chip with removed checksum and datalogging enabled. I have an nokia dku-5 usb cable. Drivers are installed, and the controller is working. I have 4 wires( black, white, blue and red)

I tested this combinations at cn2 ecu port(#1-2-4)

black, blue, white
black, white,blue
red, white, red, blue


but nothing works with turboedit. Turboedit setups was corrected( com3 and 38400 or 19200 baudrate)

Any suggestions waht the error could be?

I opened the cable, here are the pics: http://www.eurostylez.org/bilda/eg4/dataloging/

red ist not used
blue is TXD
white GRND
black I couldnt see but it must be RXD

so new wiring: (cn2 1-2-4):

white-black-blue

This doesnt work, I also checked: white-blue-black

I have no ideas anymore ...

Any suggestions?

Re: Datalogging problem
 

I think I have that same cable, did you get it off ebay for like 12 bucks? I couldnt get mine to work either (still trying) but a few people on here have. you need to look at a pin chart, hopefully you still have the end you cut off. I'll try and find that pin chart.

Re: Datalogging problem
 

Here is a link to my thread, it has a pic of my datacable in it, is yours the same one??

https://www.homemadeturbo.com/forum/...?topic=64446.0

and here's a link to that pin chart, thanks to csaddict

http://pinouts.ru/CellularPhones-Nok...p_pinout.shtml


I'm using EcuControl and cannot get mine to work either, starting to get real pissed.