d16a6 with b7 map...can someone help
im running uber on d16a6 what map should i start with b7 or y7 or z6?
|
Re: d16a6 with b7 map...can someone help
Import the P06
|
Re: d16a6 with b7 map...can someone help
you'll find the B7 and A6 maps are almost identical.
|
Re: d16a6 with b7 map...can someone help
i would say to run a y7 one if you can find it. look in the bin directory on xenocron's web site.
just due to the fact that the y7 is a 1.6 non-vtec just like the a6 the b7 is a 1.5 just my .02 |
Re: d16a6 with b7 map...can someone help
my a6 with vitaras just seems like it wants more timing from the distributor I have timing set at 25 degrees advanced and it wants more im using a b7 dizzy
|
Re: d16a6 with b7 map...can someone help
Careful with the timing my friend ;) How do you know it wants more?
|
Re: d16a6 with b7 map...can someone help
i just figured it was ok to advance the timing as long as there was no detonation then it would be okl....
|
Re: d16a6 with b7 map...can someone help
Your best bet would be to adjust timing on the dyno and use the information to help you dial it in.
|
Re: d16a6 with b7 map...can someone help
I would go with trance's advise.
If you are a Jedi Timing Master like myself, you can do it by feel. O0 |
Re: d16a6 with b7 map...can someone help
as long as there is no detonation i should be fine....correct?
|
Re: d16a6 with b7 map...can someone help
Originally Posted by bennyhonda7
as long as there is no detonation i should be fine....correct?
|
Re: d16a6 with b7 map...can someone help
A6 with P29's, broke two rods and all ringlands...........
Never heard any detonation either. |
Re: d16a6 with b7 map...can someone help
Originally Posted by Mista Bone
A6 with P29's, broke two rods and all ringlands...........
Never heard any detonation either. Vibration anywhere along the audible<-->high freq inaudible range will destroy the top rod bearing shell, fatigue metal of your rods, jackhammer on the rings/lands. |
Re: d16a6 with b7 map...can someone help
k then here is my question when trying to run the car with 16 btdc as stock, the car will not even move anywhere and the motor shakes, then when i rotate the distributor and the timing light says 35 btdcl the car will then move it would at 25 but bucked,shaked, and misfired like hell...wtf is up with that ----? afrs are fine...im just trying to get it to run...what do you suggest...how do i get it safe to drive to my neares dyno tuner?
|
Re: d16a6 with b7 map...can someone help
*uNF*
That sounds fucked up. Verify you are running stock .bin, not an Uber modified one pls kthx. Can you go over your setup? I ASSume it is an OBD0-1 conversion? Details pls. |
All times are GMT -5. The time now is 01:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands