Crome Auto-Adjust Question
#1
Crome Auto-Adjust Question
I have not been able to get this feature to work yet. I have datalogging up and running, but when i go to auto-adjust it says "no data recorded, auto-adjust haulted." If any one knows of a write up a has tipps for me it would help me out a lot. I think i have to make a lambada log, but im not sure.
#2
Re: Crome Auto-Adjust Question
go under the 'tuner settings' under thes settings tab and check all of your parameters. you have to have the right settings for gears, coolant temp, engine speed, tps, lambda difference, etc. are you getting afr readings in your lambda log, or do you just get the data logging display to the right of the screen?
#3
Re: Crome Auto-Adjust Question
Originally Posted by projekteg
go under the 'tuner settings' under thes settings tab and check all of your parameters. you have to have the right settings for gears, coolant temp, engine speed, tps, lambda difference, etc. are you getting afr readings in your lambda log, or do you just get the data logging display to the right of the screen?
#6
Re: Crome Auto-Adjust Question
Originally Posted by irocz
I also had to change my lamba range, it is recording lambada values on the table. Now I just have to figure out the auto tune part.
Originally Posted by jagojon3
bwahahahaha! Damn lambada values
#10
Re: Crome Auto-Adjust Question
Auto adjust must be nice for getting it pretty close. But you have to go through it again anyway, I used it on another program and it made it kinda sparatic. But a good way to get it relatively close. I wish crome was more appealing to me.