HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- Engine Management (https://www.homemadeturbo.com/engine-management-10/)

- - Checking codes (https://www.homemadeturbo.com/engine-management-10/checking-codes-29454/)

tranceminister

11-05-2004 05:50 PM

Checking codes

I've been curious to know if pulling codes from an OBD2-OBD1 converted ecu will work the same way an ordinary OBD1 vehichle would? Do you still jump the connector and read the blinks, or is OBD2 completely different? I havn't had to do it yet, but for future refference I'd be interested in knowing.

HMT-Admin

11-05-2004 05:53 PM

Re:Checking codes

yup on my gf's EK we have a obd2-1 jumper harness in running a p28. There is still a service connector in the right hand side that you just jumper with a paper clip. Then count the blinks of the check engine light.

tranceminister

11-05-2004 05:55 PM

Re:Checking codes

Very good info. I did notice the service connector was there, I was just a little cautios of attempting it after I switched to OBD1. Thanks for the help :)

All times are GMT -5. The time now is 01:26 AM.