Car will not start
I just finished my turbo project, and my car will not start. I am useing uberdata and 450cc injectors from tunertoys. I think that I am getting to much fuel when i try to start. I am trying to burn a new base map but i cant figue out how to save so it can be burned on my burn1. Any trouble shooting idea's would help. ???
|
Re: Car will not start
I just found out i have no spark. I probably disconected something during the installation. I gotta find were now.
|
Re: Car will not start
Yeah, check out all your plug wires and the plugs on the distributor. You had no reason to remove the timing belt or anything like that correct? Just curious to know if the timing's still set correctly.
|
Re: Car will not start
I will double check the plug wires. I did not have to remove the timming belt at all. I did do some unnessary cutting an soldering will i was installing my w/b o2 sensor. I will double check that as well. But my car ran fine after i installed the wideband.
|
Re: Car will not start
Unnecissary cutting like what? ;) It may have run after the wideband install but when you installed the turbo setup maybe a wire got loosened up ir something.
|
Re: Car will not start
When i was looking for a switch 12 volt source i tryed 2 different wires that did not work. Then i found a pin out chart on the plx devices web site and found a good switch 12v. I have to go check my wiring agin. It is hard to explane all the wiring i did.
|
Re: Car will not start
I think i figured out what went wrong. When i install my wbo2 sensor(plxm300) I concted my o2 heater wire with the resistores to the black and yellow wire on my distrurator, and that is the 12 power sorce for the ignitor. So i am thinking that it burned out the ignitor. I sould have conected the 02 heater wire the the sensor ground wire if im not mistaken, it is wht and grn pin d22. What adum mistake. Hopefully I can change the ignitor and it will stat up. :-[
|
All times are GMT -5. The time now is 10:42 AM. |
© 2024 MH Sub I, LLC dba Internet Brands