ok guys here it is. i have ghettodyne and 450cc injectors, i keep getting a cel code 5. i replaced the map sensor and same thing, code 5. i installed check valves, same thing code 5. what could this be.? is my chip fucked??

 

did u swap ecus or anything? wiring?? How much boost and how many check valves.

 

did not swap ecus, run ning 6 psi, but with ghettodyne i should not need check valves. i tried them thoiugh and installed 3 of thm. still same code 5 being thrown.

 

try burning a new chip yet? Maybe you accidentally used a NA bin?

 

look at the checksum in the bin of the file you used for the chip. Also there was 2 bins a old and a newer the older bin that came with ghettodyne caused a Cel beause of a glitch hehe...