can't launch (problem solved!!!)
 

i have mi turbo rex with uberdata basemap, when i try to launch it bogs at 3500rpm so i think it was too rich, then i make a try with an FMU but still have that problem, i have my spark plugs gap at .029.

What can cause that problem?

Re: can't launch
 

Lemme get this straight: You did an attempt at a burnout with a basemap, then ADDED an FMU to it? :l

Walter, please help him. You speak his language.

Re: can't launch
 

No, i disable the chip, remove the 450cc inyectors with resistor box, then i install stock inyectors with FMU and check valves only to see if the problem gone away but didn't work.

Re: can't launch
 

More info

Re: can't launch
 

Ok, using FMU, if i remove the turbo piping leaving the car N/A, the car runs perfect and i can launch or rev it over 7200 rpm no problem; but as soon i connect turbo piping, again i can't lauch or rev over 3k, unless i drive the car a little to pass 2k after that the car runs good.

Re: can't launch
 

hahahahahahahhahahhahahahah!!1 you said inYectors!!!!1

missing link puto.

Re: can't launch
 

Inyectors work with a yurbo :8

Re: can't launch
 

hahahaha

Re: can't launch
 

are you getting a cel?

Re: can't launch
 

map? or maybe the turbo is backwards