bucking in high rpms, Rich Or Lean?
09-01-2003, 03:44 PM
#1
1.0 BAR
Thread Starter
Join Date: May 2003
Posts: 200
bucking in high rpms, Rich Or Lean?
Ok, 8psi just hauls ***. But I am running too rich. At full throttle it doesn't cut out or anything. But if I try to just hold it at 4k or 5k, it starts bucking like a bronco.
It also does some serious bogging in low rpms when I first crank it up. Overall it is not smooth.
Any suggestions on to richen or lean out my SAFC2?
It also does some serious bogging in low rpms when I first crank it up. Overall it is not smooth.
Any suggestions on to richen or lean out my SAFC2?
09-02-2003, 10:46 AM
#3
1.0 BAR
Thread Starter
Join Date: May 2003
Posts: 200
Re:bucking in high rpms, Rich Or Lean?
My SAFC2 Setting are:
Low throttle rpms High Throttle rpms
1600 -47 -38
2000 -43 -36
2400 -43 -35
3000 -43 -33
3400 -42 -33
3800 -42 -33
4000 -42 -30
4200 -40 -28
4600 -39 -28
5400 -31 -25
6200 -25 -25
7200 -27 -25
Dec Air is Ne1 10% and Ne2 10%
Th point is Low 71% and High 72%
Low throttle rpms High Throttle rpms
1600 -47 -38
2000 -43 -36
2400 -43 -35
3000 -43 -33
3400 -42 -33
3800 -42 -33
4000 -42 -30
4200 -40 -28
4600 -39 -28
5400 -31 -25
6200 -25 -25
7200 -27 -25
Dec Air is Ne1 10% and Ne2 10%
Th point is Low 71% and High 72%
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Engine Management
31
07-10-2006 10:42 PM
Turblow
Forced Induction
2
07-05-2006 08:57 PM
azndude1983
Forced Induction
20
02-21-2006 12:33 PM
