HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Engine Management (https://www.homemadeturbo.com/engine-management-10/)
-   -   bogging and stalling? (https://www.homemadeturbo.com/engine-management-10/bogging-stalling-7081/)

kine462 07-06-2003 04:40 PM

bogging and stalling?
 
finally boosted after 1.5 years of research trips to various junkyards. dsm t-25 off a elcipse, d16y8 obd2 obstical.. no check engine lights, but ever so often at partial throttle it will bogg and jerk....my a/f gauge will go from lean to stoich.... when it's running ok (every so oftem)it will ready i green bar past rich?? could it be a fuel problem? faulty injector maybe??

Dr.Boost 07-06-2003 04:53 PM

Re:bogging and stalling?
 
I have the same problem right now. In my case it's the fuel. I'm running super rich at idle and leaning out up top. It gets jerky when I try to take off easy. I just try to punch it everytime I take off now. ;)
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

kine462 07-06-2003 04:56 PM

Re:bogging and stalling?
 
sounds good to me... are you using smc, or afc??when i am cruising partial throttle(vacuum) it will bogg and run way into the lean.. will this hurt since i am not boosting yet?

Dr.Boost 07-06-2003 04:58 PM

Re:bogging and stalling?
 
I'm using a custom chip right now. I'm trying to tune it with an AFC, but it only works to a point. I'm waiting for a burner.

It's probably not too good on your motor, but at low rpm and low load it's probably not going to blow your motor up anytime soon. I would try and get it fixed though. What are you using for fuel management?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

kine462 07-06-2003 05:00 PM

Re:bogging and stalling?
 
smc dual and 450cc dsm's

Chacko 07-08-2003 12:54 AM

Re:bogging and stalling?
 
This potentially could also be the retarded timing, your engine has to take an extra set of revolutions to 'catch up' with itself. This should especially be worse when the engine is being run on a cold start.


All times are GMT -5. The time now is 10:37 AM.


© 2024 MH Sub I, LLC dba Internet Brands