Any conflicts with using a P05 instead of a P06?
I'm seeing a few differences on the inside. On the P05 there is a resistor at R52 that the P06 doesn't have. Is that going to make a difference? Should I remove it? Any drawbacks to using the P05 instead of the P06?
Also, where does the 4 pin CN Datalogging Header go? I've looked in a few different write-ups and nobody seems to say where it goes. __________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re:Any conflicts with using a P05 instead of a P06?
Ok, I think I found out where to put the 4 pin header, CN2? I see 5 pins though. Which ones do I use? The first 4?
Also, why would I have to covert to a 4 wire o2 sensor with the P05? Why couldn't I just use the 1 wire o2? Or can I? ??? __________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re:Any conflicts with using a P05 instead of a P06?
Doc, yes your dataloging port is going to be wired into the CN2 port. As for which holes to de solder that depends on how your going to be dataloging. USB? or Serial?
|
Re:Any conflicts with using a P05 instead of a P06?
Put the header in pins 1-4.
I dont think you will have any problems running the P05 ECU...didnt you just buy a WB too? You can feed it a narrowband signal so you shouldnt have to convert to the 4-wire O2. |
Re:Any conflicts with using a P05 instead of a P06?
i use a P05 to datalogg all the time, never have a problem with it...modified just the same as my P06 that i have too...
|
Re:Any conflicts with using a P05 instead of a P06?
Thanks alot guys. :)
__________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re:Any conflicts with using a P05 instead of a P06?
I have a P05 too how u tell if its a auto or manual? Fucker on ebay said it was P06 but I got a P05.
|
Re:Any conflicts with using a P05 instead of a P06?
woo hoo i can datalog too. I just got my Max232 chip or is it the 233 i forget, it works! i hooled it up to the laptop and i get load of info. however i cant get it to work with TE only ECU control.
|
Re:Any conflicts with using a P05 instead of a P06?
Originally Posted by biggmike
I have a P05 too how u tell if its a auto or manual? Fucker on ebay said it was P06 but I got a P05.
|
Re:Any conflicts with using a P05 instead of a P06?
^^^^^Mine doesn't have any of those. ???
__________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
All times are GMT -5. The time now is 04:47 PM. |
© 2024 MH Sub I, LLC dba Internet Brands