450's installation No pic Question??
 

I know what you might say SEARCH https://www.homemadeturbo.com/forum/...ges/search.gif an I have but I just one a quick yes or no answer.

I have an 88dx hatch with mpfi swap and a SOHC Vtec ZC, & PM6. Turbo was done usinf an FMU. Now I'm ready to upgrade, 450's and Turboedit.

From what I have read, the car already has a resistor box, of course, so all I need to do is put in the 450's right? Take the old ones out, bore out the lower seals, put in the new injectors, cut out the little tab on the connector, plug the clips, install chip, run the car.
Am I missing something?

I'm still waiting for the chip to get here, TurboEF9(Jason) hooked me up, but should be here in a little while, and I want to make sure I have the 450's in there correctly.
Thanks

Re:450's installation No pic Question??
 

Hotrex taught me how to ship... :-[

Re:450's installation No pic Question??
 

haha, I know, don't worry, I know it'll get here sooner or later. But do I have everything pretty much installed right? Just want to be ready for when it get's here.

Re:450's installation No pic Question??
 

Ya.. if your MPFI swap is working fine, then all you have to do is drop your 450s in.

Re:450's installation No pic Question??
 

Yep, the mpfi swap worked perfect after I did it before turbo, for about 4 months or so, so I know it's working fine, no CEL or anything, and I did it all myself, I'm so proud ::).
Another question, with turboedit I don't need check valves right?

Re:450's installation No pic Question??
 

Correct.

You *want* TurboEDIT to see boost. Checkvalves bleed the boost off (Like a missing link) so that the ECU doesn't see it.

Re:450's installation No pic Question??
 

ooooKAY, I think I found out, why my car was running a little shitty the last time I drove it. While I was doing the 450 install, I saw that 2 of the 3 check valves i had there came off. ;D ;D

How I don't know, but I'll just wait for turboedit ;)