HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Engine Management (https://www.homemadeturbo.com/engine-management-10/)
-   -   450 tuning (https://www.homemadeturbo.com/engine-management-10/450-tuning-36482/)

kylecrews 03-23-2005 05:59 PM

Re: 450 tuning
 
Since I had to raise the fuel so much I just took the injectors back out without trying to tune the rest of the rpm band at 14% correction because that seemed like to much to me. I put the stock injectors back in and put the afc setting back to 0% correction and the the car runs fine. Just trying to fugure out why I have so much latency correction

TurboEF9 03-23-2005 06:16 PM

Re: 450 tuning
 
I don't know.. maybe your ECU hadn't had time to adjust short/long term fuel correction. At idle, you're running in closed loop. Your ECU isn't going off of 100% pulse durations. It's reading the sensors.

You should drive it around for a bit... be easy on it. It'll pan out.

kylecrews 03-31-2005 12:33 PM

Re: 450 tuning
 
I just install my injectors last night again and had to turn the low thr. all the way up to -28 at idie after the car warmed up and slowly went up to 25 by 4 grand then 25 on out. On the high thr I set it around -36 all the way accross and my cross over point to 30 and 40. I tried 75/76 crossover point but at 40 to 60 % thr the car was going up to 10.** A/F. I played around with different crossover points and A/F settings till I got the one above and I found that one and now anything below 30 to 40 % thr I'm at 14.** and then 30 to 40% and above at 13.** to 12.** and I'm at 12.** at WOT and 14.7 at idle. Before I put the injectors in I ran the car with the WB to see what the A/F ratios should run at all rmps and then put the injectors in and I was able to make it run almost like stock within about two hours. I still have a little more tuning to do to get it just right but the car is running pretty good right now. I am going to take some short vid's of my WB and SAFC together at different thr points and post them this weekend so you guys can take a look at them and tell me what you think. I'm not the best at describing things so I'm sure this is not exact which is why I am going to post the vids which will show the A/F verse RPM and Cor. amount with thr. positiion. Maybe I might be able to get some pointers from some of the tuners here once the vids are up. Thanks.

Also I have never posted a vid on here or anywere so I'm not really sure how. The vid's will be on my friends camera that takes short vid's just wondering how to post them?


All times are GMT -5. The time now is 07:27 AM.


© 2024 MH Sub I, LLC dba Internet Brands