2.5bar and total timming Q!
 

I'm kind of confused about the total timming when using 2.5bar map sensor with Uber. Total timing with stock map @ 10psi is about 19.50* and when i mock up a map for 2.5bar sensor @ roughly 10psi its about 27.00*?? Even if i plug in .9 retard in the step retard in all of the fields it still ends up way more than 19.50*.
any insight is appreciated.

if your gonna try to flame me for asking a Uber question on this forum then eat a dick b/c i would rather keep this indirect question and its info on THIS forum.

Re: 2.5bar and total timming Q!
 

Uber doesnt take the rescaled load scalars into account when you change map sensors. You'll just have to sit down and figure it out by hand. ;)

Re: 2.5bar and total timming Q!
 

ah... thanks.

Re: 2.5bar and total timming Q!
 

hmmm....does crome do it?...if not that would explain some stuff

Re: 2.5bar and total timing Q!
 

yeah, can you imagine 15psi and 26* of total timing. :-X

Re: 2.5bar and total timming Q!
 

Crome does it.

Re: 2.5bar and total timming Q!
 

you get an e-hug for putting the crome firmware on my ostrich then