window weld vs pre made inserts
#1
window weld vs pre made inserts
whats stiffer? pre made inserts like ES engine mount inserts or cured 3m window weld?
i was to stiffin my engine up a bit but not so stiff my car feels all buzzy and junky... im thinkin just do the side mounts with window weld
i was to stiffin my engine up a bit but not so stiff my car feels all buzzy and junky... im thinkin just do the side mounts with window weld
#5
Re: window weld vs pre made inserts
I tried that window weld ---- and just made a sticky mess everywhere. I ended up buying jimfab motor mounts (all 3 lower mounts) for $110 shipped. It eliminated my wheel hop and my motor is rock solid. The car rattles a bit, but it's worth it lol.
#6
Re: window weld vs pre made inserts
i see inserts all over the place, but every time ive seen them up close they always look wrong. are they just supposed to fit inside of the old motor mount or are you supposed to take out the old motor mount filling and replace it completely. ive used stock ones forever and they are getting pretty shitty now, plus the front tranny mount has been hollowed out completely by hard launches, so it might be time to replace the mounts.
#7
Re: window weld vs pre made inserts
The only advantage that I can see to the inserts is the ability to remove them if need be. You can also try different combinations to alter stiffness or vibrations. I guess you could do the same with two sets of mounts(one set filled).
#9
Re: window weld vs pre made inserts
I've had both ES ones and filled ones. The 3m stuff started to fall apart on the front mount after a year, probly from the heat and getting sprayed by oil and motor bits a few times. The others are still fine.
Right now I'm running inserts on the front and back mounts, and 3m filled ones on the sides. Car is a bit buzzier since I swaped out the front and back for ES ones.
Right now I'm running inserts on the front and back mounts, and 3m filled ones on the sides. Car is a bit buzzier since I swaped out the front and back for ES ones.