who runs DIYAutoTune here
#6
Re: who runs DIYAutoTune here
I've built one but havent used it yet. I'm gonna make a plug-n-play MS harness for my volvo. It'll hookup to the standard ECU plug. Nifty
Edit: GlensGarage.com is a good place to buy from. Everything is packaged and labelled. Fool proof assembly.
Edit: GlensGarage.com is a good place to buy from. Everything is packaged and labelled. Fool proof assembly.
#9
Re: who runs DIYAutoTune here
Originally Posted by tr4cti0n.i55ues
i think rabbitshit was one of the first to run megasquirt but i dont think he is on here much
edit: or are you asking who runs the company?
edit: or are you asking who runs the company?
#10
Re: who runs DIYAutoTune here
well if your going to get a prebuilt unit, then cool. props to ya.if not, then go get it from glens gerage. tell him you need the ---- asap because it might take him a month to ship. anyways, if you going to do it yourself, you need a ocuple things.
1 Soldering iron. 20 to 30 watts is fine.
1 roll 60/40 .062 dia standard rosin-core solder works just fine.
1 desoldering bulb.
1 tube rtv or silicon compound.
a pair of small or micro wire cutters.
a small pair of needle knose pliers will be dandy helpfull
a db9 serial cable.
(if your getting the stimulator, add 1 9v battery)
and your good to go. as far as the harness goes, it depends on what rout you wanna go.
and some experience and knowledge to properly solder.
also before you do these things, mak sure you have all the provisions too. like if your gonna run certain things, like water temp, airtemp sensors, and a wb02 sensor is strongly suggested.
1 Soldering iron. 20 to 30 watts is fine.
1 roll 60/40 .062 dia standard rosin-core solder works just fine.
1 desoldering bulb.
1 tube rtv or silicon compound.
a pair of small or micro wire cutters.
a small pair of needle knose pliers will be dandy helpfull
a db9 serial cable.
(if your getting the stimulator, add 1 9v battery)
and your good to go. as far as the harness goes, it depends on what rout you wanna go.
and some experience and knowledge to properly solder.
also before you do these things, mak sure you have all the provisions too. like if your gonna run certain things, like water temp, airtemp sensors, and a wb02 sensor is strongly suggested.