aracer69

Has anyone changed these and how hard are they to remove by yourself?

projekteg

you have to have your hub/spindle pressed out with a bearing press, if you have or have access to a bearing press, not to tough. you're prolly better off going to the junkyard and pulling a whole knuckle, that's what i did anyways

crxfreak88

If you do it yourself donot forget the snapring. While it is possible to beat them out with a hammer and in , my machine shop charges 15 bucks so in the end is it worth ruining a 60 dollar bearing?

45psi

i vote for the junkyard pull. i dont have hydrolic press

accordepicenter

Just beat it the hell out to get it off, then sand the knuckle just a little bit so you can tap the bearing back in without damaging it, and itll work just fine.