Which welder to buy???
#1
Which welder to buy???
i think ima do my own downpipe since everyone else seem like they gonna charge me a arm and i leg
what AMP welder would be strong enough to do this?
or what kind?
and i should have been done with this kit a while ago tryin g to get it done
pics are here at www.artistontheloose.com in the projects section
check'em out
what AMP welder would be strong enough to do this?
or what kind?
and i should have been done with this kit a while ago tryin g to get it done
pics are here at www.artistontheloose.com in the projects section
check'em out
#6
Re:Which welder to buy???
oxy/ace welding (gas welding) method is good, but hard to perfect it from what I heard. The bad thing I heard about oxy/ace setup is that it heats up the hole metal and it warps more VS if it were a MIG welder. Id get a MIG welder. Its easy to learn and use. If your really good at it, get a TIG welder. MIG welders uses gas because of the sheilding the wire (by using mig wire). There is also a fluxcore wire which does not require the use of a co2/argon mix tank. Oh, if you looking for a welder Id suggest looking for one with a MIG capability! so atleast you wont be buying two welding machines.
hope this helps....I dont know much about welding! I have 5 mintues of experience! thats all...im just a newbie myself
hope this helps....I dont know much about welding! I have 5 mintues of experience! thats all...im just a newbie myself
#7
Re:Which welder to buy???
Get a MIG/Flux core combo. In case you run out of gas you can use a flux core wire. MIG will have better result than flux core though. A MIG welder with the right parts can also weld aluminium and stainless steel. TIG welding is the hardest to learn, but makes the best weld. TIG welders are usually a lot more expensive too.
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Fabrication
21
02-13-2007 05:20 AM
crx2fast
General Discussion
0
01-22-2007 12:50 AM
rsmith2786
Fabrication
12
06-03-2006 03:53 PM