Water temp gauge...
#1
Water temp gauge...
Just swapped my z6 into my 89 rex... and everything (except Vtec) is working fine... except the damn water temp gauge. I took that ******(water temp sensor) off the a6 the rex had and it worked beforehand. now, when i turn the car on, instead of the gauge going up, it moves down a little more and stays there. i tried to switch the two wires on it, but that also didn't work... any help would be appreciated. thanks
dan
dan
#3
Re:Water temp gauge...
uummmm well i'm not sure why your gauge is doing that but i know that on my engine i don't have the sensor hooked up anywhere i just use the oem temp sensor. if your looking at your engine bay, in the upper right corner their is a batch of cables, in one of those plugs their should be a yellow w/ green wire (i'll have to double check when i can) and my water temp gauge is spliced right into that wire and it works like a charm. i'd say give that a try and if your water temp works good then u know it's your sensor. good luck. post what happens
-Kaelon
-Kaelon
Thread
Thread Starter
Forum
Replies
Last Post
SQ is the SQUAD
Turbo Parts For Sale
0
04-09-2006 08:54 PM
quadtech
Turbo Parts For Sale
3
10-19-2005 01:53 PM