TwinTurbo V12 final setting :)
#1
TwinTurbo V12 final setting :)
So,after doing it 3 differents way, here is the final one ... "very good flow", no commun firing cylinder in each exhaust pipe.
I did weld it like a pig ... basically,I prefered to tripped all the welding, and then erode itif required. I just tested the all side at 30bars ... no leak.
I spend a long long time to make sure I can fit those big *** T04b from Garrett. This set up fit under the hood.
I am not happy of the "look of my welding, but I had to mix different kind of standless steel, and some time , it was getting too "sparking" ... I made sure that the penetration is very deep everywhere, it is what matter the most to me ... I don t want to burn the car...
I am now cutting a lot of little piece to steel to make heat shields ... I ll wrap the exhaust into a full thermal shield, but additional protection is required for the spark plugs wires.
May the Core be with you!
That is hand made !!!!
FrancoisP
http://www.v12extreme.com
vrooooommmmmmm
I did weld it like a pig ... basically,I prefered to tripped all the welding, and then erode itif required. I just tested the all side at 30bars ... no leak.
I spend a long long time to make sure I can fit those big *** T04b from Garrett. This set up fit under the hood.
I am not happy of the "look of my welding, but I had to mix different kind of standless steel, and some time , it was getting too "sparking" ... I made sure that the penetration is very deep everywhere, it is what matter the most to me ... I don t want to burn the car...
I am now cutting a lot of little piece to steel to make heat shields ... I ll wrap the exhaust into a full thermal shield, but additional protection is required for the spark plugs wires.
May the Core be with you!
That is hand made !!!!
FrancoisP
http://www.v12extreme.com
vrooooommmmmmm
#3
Re: TwinTurbo V12 final setting :)
First off, what the ---- are you doing welding in your living room. Your moms going to kill you if you burn down the house. 2ndly, is that thing going to run or just go the stealthmode route and sit on jackstands. If it going to run, you may want to consider sitting the turbo flat for oil drain.
Just kidding about the living room, that fucken rocks.
Just kidding about the living room, that fucken rocks.
#9
Re: TwinTurbo V12 final setting :)
that thing looks like ---- and that motor is nothing but a cool *** looking paperweight. buy a pushrod v8 and stop mounting turbos half *** calked ------ style sideways upside down that will never work