pito3331

i need help snapped 2 head bolts in my gsr after doing a headgasket on it now i dont have compression so it wont stay on. how do i get the bolts out it snapped at the bottom so far down in and i dont know how 2 get them out or wat 2 do!!! plz someone hel;p me out.

jinxy

a drill a few good bits and an easy out, hope you can find an easy out small enough, and hope you dont break the easy out

88dx

how the ---- did you snap a head bolt

Slo_crx1

That's what i wanna know. Geez, what did ya use to tighten it...a breaker bar? I doubt you'd be able to get an EZ Out that far down. Probably have to take the block to a machine shop, and they might not even be able to get it out without drilling the whole thing out. But at least there they have the proper equipment for it, and could come up with a workable solution for ya.

70Challenger

yeah i doubt an easyout will do the trick, only because it doesnt seem like there will be enough to grab onto. Your most likely going to end up having to redrill and tap. How far down in did it break? Is there enough thread showing in the hole that you could put a shorter bolt into it and tighten it without bottoming out onto the broken piece? Its super ghetto, but it might buy you some time until you could get it fixed properly... i dont know if this would really work, but maybe worth a shot

ichbinsobose

JB weld the broken piece on. The head studs are not important, they just the vtec down onto your block.

J-SMITH69

ya seriously LOL

SkunT

your retarded.

machine shop time. i woudlnt try an easy out on that one.

90dx

You really should just pull the motor and get the block down to a machine shop.You will most likely make it worse by trying to remove it with a easy out or similar.You should buy a torque wrench or get your's calibrated.

hotrex

classic retardation