shanerv

my quest for ls vtec is almost done, but I still am not sure which ecu/harness, axles, or mounts to use to swap the 91 ls/vtec into a 5th gen civic. so if anyone can help me out with this info as well as the parts, thanks guys

PinoyB18A

Integra Axles, and HCP B-series mounts for your car. I think there's a write-up on the Main Page...

1337

Ehhh for a eg civic all you need is all the stock mounts from a 3rd gen integra. Don't need no fancy pants billet urethane expensive marked up priced mounts :P

BoosTedZSix

use your existing harness from the eg. and u need an obd1 distributor and ecu if u didnt already know that. if your car wasnt an si. then u have to run wires for vtec and vtec pressure.

shanerv

axles from which integra? a 90-93 GSR?

shanerv

also, I have a cable S1 tranny which has the mount on the front of it as apposed to the top. how will this work? I only ask because I JUST got the car and havent even had a chance to look yet but does the civic have a cross member where theres a mount in it that the tranny bolts to or am I going to mave to modify this??thanks again guys

shanerv

I was trying to figure out too if I could get a obd1 (90-93) GSR ECU and run that. then I wont need a relay for vtec. but I would probably need ot chip it to spin to the ls's 8200 and to get a more appropriate fuel map.

87na_rx7

Your going to rev the stock ls bottem end to 8200?? You better say hello to oval shaped cylinders

shanerv

of coarse I am. I hear of everyone revving their ls/vtec's to 8500 all the time. so I figured that by setting the limit at 8200 aught to be a safe bet

1337

You can use stock 3rd gen teg axyles