Turblow

Im about to swap my SSAC t04e into my crx and I realized I have a problem.

The instructions say to hold the wheel firmly when its started and to hold it for 30 seconds until oil is all over it. I thought sure I can do that

Ofcourse I never thought I would be all alone until almost 12pm tonight and frankly I just cant wait that long

How can I do this myself?

Thanks guys

anothercivic

Don't cut off any fingers. Just disconnect your fuel pump relay and prime it by cranking your engine.

J-MAN

just start it
not like your gonna ruin an SSAC turbo, those thing wouldn't break if you threw it off the roof. quality stuff i tell you.

Turblow

If the motor isnt turned over the oil pump is still priming? Alrighty that works then

anothercivic

The motor isn't gonna turn on but its still gonna crank...

buk9tp

get ur neighbors to help you ffs.. you hold it while theey start it up..

ososlohatch

lol stick your dick in the inlet and yell for your moms to come start the car

Zeniceguycrx

run a wire from the batt terminal to the starter trigour(with the key off)this will turn the engine over but wont start

Inquisition

I believe pulling the ECU main fuse next to the battery will prevent the car from starting(well I know it will do that) but I believe it turns on the oil pump. Then you can just crank over the engine a couple of times and the oil should circulate. Sticking your hands in a turbo while the engine is running is just a bad idea in general.