need help with this welder
#1
need help with this welder
I got a Miller XMT 304 CC/CV from a guy over here in Iraq. The guy said if i can get it workign I can have it. I wired it up 3phase and the code comes up for "Thermal protection malfunction" As this unit new is about $3500 i hope to get it fixed or possibly fix it myslef. I figure even if i spend 1500 on parts for it im still up another 2000. Anyway my question is there anyone that is good with troubleshooting them or fixing them? I will be back in the states next month and hope to get it fixed soon after i get back. Im not sure it the post office will ship it in a protective container or if i will have to ship it back with my units equipment. Either way I will get it home to the states. Can anyone help?
#3
Re: need help with this welder
Originally Posted by accordepicenter
you have 3 phase power?
You name is as far as electricity goes i have it im a refrigeration mech and a electrician. A/C and electricity is what i do out here.
#5
Re: need help with this welder
Originally Posted by MyVtec8yourV8
You name is as far as electricity goes i have it im a refrigeration mech and a electrician. A/C and electricity is what i do out here.
Obviously there's a short somewhere in the welder.
#6
Re: need help with this welder
Originally Posted by SloS13
Originally Posted by MyVtec8yourV8
You name is as far as electricity goes i have it im a refrigeration mech and a electrician. A/C and electricity is what i do out here.
Obviously there's a short somewhere in the welder.
its crazy some of the things you can do.. did you know you can change the oil in your own car IF you KNOW HOW?
#9
Re: need help with this welder
Originally Posted by SloS13
I was joking. In your post you say you're an electrician so that left me wondering if you expected someone more qualified than an electrician to chime in and tell you how to fix it.
but im an electrician but have no clue about "thermal protection" in welders. i wish i did.. but i got a few numbers of places to send it to to have it fixed.. i was hoping for a chime in of someone who may have dealt with stuff like this befor.
Thread
Thread Starter
Forum
Replies
Last Post
Turblow
Fabrication
21
02-13-2007 05:20 AM
crx2fast
General Discussion
0
01-22-2007 12:50 AM
W O T
General Discussion
14
01-25-2006 08:38 PM