My "secret" project... (newest dyno graph updated)
11-19-2004, 09:33 PM
#48
3.0 BAR
Thread Starter
Join Date: Oct 2003
Posts: 3,254
Re:My "secret" project... (newest dyno graph updated)
I cleaned up the A/f ratio a whole lot and put a bunch of timing in it. also the first tune was running on a p2p ecu w/ a knock sensor code (may or may not have effected something) now it is on a P28 w/ no codes. I have some ideas to pull a little more out of the setup (the step between the runners and the manifold isn't cleaned up, I didn't taper the ends of the runners, and I don't have any stacks) we'll see what happens w/ it.
and actually I used the plotting function on the dyno software and it topped out at (not including the surge) about 132 it is hard to see because the graph is so cluttered on the comp. screen it was a whole lot more clear.
and actually I used the plotting function on the dyno software and it topped out at (not including the surge) about 132 it is hard to see because the graph is so cluttered on the comp. screen it was a whole lot more clear.
11-20-2004, 04:56 AM
#50
Administrator
Join Date: Dec 2002
Posts: 13,991
Re:My "secret" project... (newest dyno graph updated)
Nice work bamboo, 140 on a z6 is pretty good, boosted ITB setup should be fun too. I'd definatly get the rev limit raised on that thing, It looks like you could squeeze high 140's out of that thing by 8 grand. If you look the torque hasnt even fell off at all.
