Kains project rx7 tidbits.
01-02-2006, 02:40 PM
#13
3.0 BAR
Thread Starter
Join Date: Sep 2003
Posts: 5,448
Re: Kains project rx7 tidbits.
Originally Posted by Rx7toCivic
i dont see why you got the intake, are you going to use na rotors in t2 housings? thats the only way that intake will bolt up. If your planning on just putting the turbo manifold on an na motor yout going to need a spacer that pushes the turbo from the block, and possibally a notch in the frame
or my other rout im tossing around in my head right now is .. a .. well... a itb setup, with the turbo and stand alone, but thats a lil more money then what i wanna deal with.
01-02-2006, 03:01 PM
#15
3.0 BAR
Thread Starter
Join Date: Sep 2003
Posts: 5,448
Re: Kains project rx7 tidbits.
well... i got the new door on and painted flat white. i also did the front fender cus that had a minute dent in the front tip. i hated that dent cus it was soo obvious. so i went ahead and ghetto fixed that. i mean its not perfect, but for a 2 hours fix it job, and to the untrained eye, it looks damn good.
01-02-2006, 06:11 PM
#18
3.0 BAR
Thread Starter
Join Date: Sep 2003
Posts: 5,448
Re: Kains project rx7 tidbits.
well... after doing some reaserching and some asking, i find out, that, dun dun dun. my turbo unit uses to4 parts. so that means basically most any t04 part can be fitted. boy o boy am i gonna have some fun with this.
and after thinking about it, my poopy 300 whp is kinda lame. i might aswell go the full way and do a t2 tranny swap, and boost the ****** to 400 whp.
and after thinking about it, my poopy 300 whp is kinda lame. i might aswell go the full way and do a t2 tranny swap, and boost the ****** to 400 whp.
