Just an idea
#1
Just an idea
Just a though for cheap b-series pistons. I was looking on ebay and found 7mgte pistons. There 83mm bore, wrist pin is 21.996mm, comp is 8:5:1 in the 7mgte. So from the looks of it you would just need to over bore to 83mm and line hone the wrist pin a bit. Not 100% sure it will work but if it does could be a cheap way to go.
#4
Re: Just a idea
Originally Posted by marcj
also, in regards to the title.. an always comes before any word that begins with the letter i. "Just an idea"
edit: an comes before any word starting with a vowel.
just wanted to clarify that
edit: an comes before any word starting with a vowel.
just wanted to clarify that
Not sure on the hight, let me keep looking.
Edit fix
#7
Re: Just an idea
Yah, Hitchhikkr says the compression height is too tall. Also, they aren't a strong piston and they aren't forged so not worth the hassle.
My $0.02 on the subject is boring out the small end of the rod a whole mm doesn't make me feel too great about the idea.
My $0.02 on the subject is boring out the small end of the rod a whole mm doesn't make me feel too great about the idea.
Thread
Thread Starter
Forum
Replies
Last Post
BLACK_DEL_SOL
General Discussion
4
05-06-2004 11:39 AM
fongaroos
Engine Management
5
04-16-2003 11:59 PM