i spun a rod bearing
#21
Re:i spun a rod bearing
Originally Posted by 87na_rx7
Note to self: Never buy car from whitey.
I think Jeff would cry if I described how I put together my GSR before I sold it..
Is it ok to undertorque rod bolts becuase you used NAPA rod bearings that were completely off spec?
Also, is it ok to rebuild a motor while there's still a chunk of piston melted to the wall and after 10 minutes of honing the ---- out of it just say ---- it and pretend its not there. :P
I can go on...
#23
Re:i spun a rod bearing
Since I only fucked up one cylinder I took one used piston from my buddy's GSR and just put that in. Since the walls were slightly egged it was a tight fit and that cylinder has about 4 psi higher compression than the others so its all good.
Head gasket was reused of couse
I only had LS rings so I used them so there was no need to file any ringgaps.
Suprisingly the car is still running strong to this day.
Head gasket was reused of couse
I only had LS rings so I used them so there was no need to file any ringgaps.
Suprisingly the car is still running strong to this day.
Thread
Thread Starter
Forum
Replies
Last Post
mij_nagrom88
General Discussion
19
11-27-2006 02:44 PM