HMT goes to Woodburn Dragstrip! ::PICS:::
#31
Re:HMT goes to Woodburn Dragstrip! ::PICS:::
All the charge pipes have beads on them, I'm just going to use some different coupler material and double up the clamps. It will be fine.
Oh, and that guy in the wheel chair, hahahah.. Man this guy with a built h22 all motor (exhaust side exit) was doing a burnoff and it about blew the guy over on his chair. LOL
Oh, and that guy in the wheel chair, hahahah.. Man this guy with a built h22 all motor (exhaust side exit) was doing a burnoff and it about blew the guy over on his chair. LOL
#32
Re:HMT goes to Woodburn Dragstrip! ::PICS:::
up at a nearby shop, (Gearheadz) on the supra they race. they put a pin perpendicular to the pipe and then one on the other other pipe it connects to. then there is a rod that goes in between them and secures the charge pipes.
i dont know if you know what i mean, but i will have to get pics to really show you. they said this completely elimnates the charge pipes blowing off. and since you can weld... but then again, new couplers might also do it too with more clamps.
looks like everyone had fun.. cept bbka (who seems like he is having a bad luck streak with the racetrack issue).
i wish it was warm enough here to race... :-/
i dont know if you know what i mean, but i will have to get pics to really show you. they said this completely elimnates the charge pipes blowing off. and since you can weld... but then again, new couplers might also do it too with more clamps.
looks like everyone had fun.. cept bbka (who seems like he is having a bad luck streak with the racetrack issue).
i wish it was warm enough here to race... :-/
Thread
Thread Starter
Forum
Replies
Last Post
FooK
General Discussion
7
05-31-2005 11:22 PM
playboyace35
Forced Induction
18
05-08-2004 07:40 PM
turbowagonman
Engine Management
0
06-20-2003 10:35 PM