HM swaybar link repair
#1
HM swaybar link repair
so isuzu is pretty ------ retarded with its plastic rivets holding balljoints to steel cups and 1/4" rod setup.
they always break, and this one side luckily didn't.
how'd i fix it? welded 4 gr8 1/2" washers together, welded a 3/8"x1.5 bolt. did this 2x, one for top, one for bottom.
welded two 3/8"x2" bolts to the end of 1/2" x .125wall pipe, used all gr8 hardware.
double nutted gr5 nuts for a locknut, but didn't make them super tight in case it gets really twisted up.
wish i could have just used one long bolt like everyone else, but nooooo they gotta nog it all up.
they always break, and this one side luckily didn't.
how'd i fix it? welded 4 gr8 1/2" washers together, welded a 3/8"x1.5 bolt. did this 2x, one for top, one for bottom.
welded two 3/8"x2" bolts to the end of 1/2" x .125wall pipe, used all gr8 hardware.
double nutted gr5 nuts for a locknut, but didn't make them super tight in case it gets really twisted up.
wish i could have just used one long bolt like everyone else, but nooooo they gotta nog it all up.
#3
Re: HM swaybar link repair
Originally Posted by rawr
ok, so felt and a ghetto washer are going to work better :1
You fail at explaining things on IM.
You fail at explaining things on IM.
Thread
Thread Starter
Forum
Replies
Last Post
JolToN49
Turbo Parts For Sale
19
08-06-2006 07:46 PM