help with brakes
03-31-2006, 08:00 PM
#4
1.5 BAR
Join Date: Dec 2005
Posts: 1,129
Re: help with brakes
you didnt do this by yourself, did you ?? get someone in the car to pump the brake while you bleed them. make sure the pedal is hard, I usually pump it ~20 times on each wheel. Do it again and tell me how it is.
03-31-2006, 08:05 PM
#5
3.0 BAR
Join Date: May 2003
Posts: 6,279
Re: help with brakes
you need to bleed the master cylinder ITSELF before u put it on.
Use rubber lines to route all the in/outlet of the MC back into the resvior, fill it up with brake fluid then hand pump the piston until all the bubbles came out. Then put it back on , connect all the lines and bleed all 4 wheels.
Use rubber lines to route all the in/outlet of the MC back into the resvior, fill it up with brake fluid then hand pump the piston until all the bubbles came out. Then put it back on , connect all the lines and bleed all 4 wheels.
03-31-2006, 08:06 PM
#6
1.0 BAR
Thread Starter
Join Date: Mar 2006
Posts: 519
Re: help with brakes
i had my dad pump the brakes while i bleeded them through the bleed nut and i stoped when there were no more air bubbles in the clean hose i hooked up to the bleed nut.....i dont remember if he had the brake up or not...would that make a difference?
03-31-2006, 08:15 PM
#8
Guest
Posts: n/a
Re: help with brakes
You don't get it, you need to bench bleed the master cylinder. This means taking it off of your car and putting it in a vice.
You use some fittings that screw into where the brake lines would go into the master cylinder, and connect the lines back into the reservoir. Then you basically push on the cylinder with whatever you have laying around that works (screwdriver, extension, etc.) until the bubbles stop.
You use some fittings that screw into where the brake lines would go into the master cylinder, and connect the lines back into the reservoir. Then you basically push on the cylinder with whatever you have laying around that works (screwdriver, extension, etc.) until the bubbles stop.
03-31-2006, 08:22 PM
#9
1.5 BAR
Join Date: Dec 2005
Posts: 1,129
Re: help with brakes
when i did my drum/disc conversion i only bleed the four weels not the MC. this is how you do it. let your dad pump the pedal until it gets hard, make sure he has the brake pedal pushed in, then loosen the nipple(or whatever its called)then tight it. do that a few times 3 or 4 on each wheel. handle brake has nothing to do with it.
