Gutting a stock map
#1
Gutting a stock map
I remember a while back i saw a thread on how to gut a obd0 Map sensor, like getting all the epoxy out and putting a 2.5 bar inside of it etc.. Pretty sure it was here but it may have been on H-T. Anyone have a link, i can't find it for the life of me.
#2
Re: Gutting a stock map
Originally Posted by Smokey
I remember a while back i saw a thread on how to gut a obd0 Map sensor, like getting all the epoxy out and putting a 2.5 bar inside of it etc.. Pretty sure it was here but it may have been on H-T. Anyone have a link, i can't find it for the life of me.
i should kick you in the ***** for confusing this site with honda tech
#3
Re: Gutting a stock map
Originally Posted by Smokey
I remember a while back i saw a thread on how to gut a obd0 Map sensor, like getting all the epoxy out and putting a 2.5 bar inside of it etc.. Pretty sure it was here but it may have been on H-T. Anyone have a link, i can't find it for the life of me.
lmk when you find it.
#4
Re: Gutting a stock map
#5
Re: Gutting a stock map
What's so difficult about gutting a stock MAP and stuffing a Motorola unit inside it? I've been doing it for years; MADMAX got the idea from reading my pgmfi.org posts. The potting compound is annoying if you use hand tools, but the stealth is worth it. Drill press does it in 15 minutes.
#6
Re: Gutting a stock map
Ya i got it figured out, i had the epoxy scraped off but i couldn't get that little tin part out, i ended up just cutting it with a dremel down the middle and then prying it out. ---- that goop is a pain in the *** to get out tho.
Thread
Thread Starter
Forum
Replies
Last Post
#Leo#
Engine Management
25
12-02-2008 04:52 PM