Jorsher

I just got back from a week vacation and have tomorrow off before I get to my 80 hour work week so would like to finish installing the keyless entry and door handles.

I think I've figured how how I'm going to place the solenoids, and got the passenger handle in.

Here's what I want to know:

1. How/where have you mounted the actuators for keyless entry in a CRX
2. What do I need to remove to run the wiring through the rubber hose that oem wiring runs through in the doors to the chassis. Dash? What?

Thanks

JonDouglas

I stuck my actuator in the hole where the rods for the latch and lock come through the door.

I also ran a separate loom for the wiring. It was a total pain in the ***, but worth it in my opinion.

Jorsher

Yeah that's where I'm considering putting my actuator as well.

I'd rather use the oem loom though since it's already there and would be one less thing for me to ---- with.

So what do I need to remove people? Dash? What. I need to know so I can estimate how much time I'll need since repairs of any kind are "banned" at my apartment and I'll have to schedule time and go somewhere else to do it. They left a violation sticker on my car for a flat tire (some ---- put nails in it before the tire even had 100 miles on it, ---- buying a new one I'll pump it up every week). Put it right on the ------- windshield so I can't drive without removing it, which is a pain in the ***.

I left them a big sticker saying "tire is pumped" on the front window of the apartment lobby.