Call me crazy
#1
Call me crazy
Doing some experiments which I will reveal later
I have a couple questions.
Im working on a project that will be powered by my old D16A6
what all is needed for it to run correctly outside of a crx?
rking on a project that will be powered by my old D16A6?
its mounted on a frame.
Ive got a pm6 fuel pump wired and a gas tank
what else will be needed?
will the vehicle speed sensors and such affect this?
I have a couple questions.
Im working on a project that will be powered by my old D16A6
what all is needed for it to run correctly outside of a crx?
rking on a project that will be powered by my old D16A6?
its mounted on a frame.
Ive got a pm6 fuel pump wired and a gas tank
what else will be needed?
will the vehicle speed sensors and such affect this?
#2
Re:Call me crazy
you need everything a computer would need to operate. So yeas every sensor that came on the engine orignally, proberly a tranny (maby maby not)and a wire loom from a CRX or whatever ECU you will be running on it.
#7
Re:Call me crazy
I wanted to do the same thing...Maybe will still do it with a high comp D15B7 with MPFI. that I have in my shed...You just need the engine no tranny ..need every component starter, alternator etc.. the ecu...wires etc.. battery a fuel cell and fuel pump. So the whole engine with all the parts sensors etc...fuel cell feul pump everyhting connected and it should start....just hot wire it, or if you want to make it simle put an ignition switch on it or a start button. You can put the gauge cluster to monitor RPM etc if you want.
Thread
Thread Starter
Forum
Replies
Last Post
scottsi
General Discussion
42
06-22-2005 02:03 PM