to any one that has taken a tranny apart
#1
to any one that has taken a tranny apart
ok i am replacing the mainshaft bearing and seal and i cant seem to get the clutch houseing apart from the tranny..
i have removed the 12mm bolts that big 19mm and the hex head bolt... is there some kind of trick? to get it apart. it will open up like 1 inch but something stops it...and i dont want to jerk on it and break something so please help asap..
justin
i have removed the 12mm bolts that big 19mm and the hex head bolt... is there some kind of trick? to get it apart. it will open up like 1 inch but something stops it...and i dont want to jerk on it and break something so please help asap..
justin
#3
Re:to any one that has taken a tranny apart
yeah, that big "bolt" on the end, that you remove with a 3/8" driver, holds a snap-ring underneath it...
I tried for hours to get my tranny apart, and then my buddy came over and he knew the deal, and we had it in pieces in like 5 minutes =D
-Henry
I tried for hours to get my tranny apart, and then my buddy came over and he knew the deal, and we had it in pieces in like 5 minutes =D
-Henry
#4
Re:to any one that has taken a tranny apart
basically you want to life the PASSENGER side housing off the clutch housing
take all the bolts out, theres some on the side that have springs/ball bearing in them that should come out too. and then that friggen snap ring, dont forget that. i hate that thing
take all the bolts out, theres some on the side that have springs/ball bearing in them that should come out too. and then that friggen snap ring, dont forget that. i hate that thing
Thread
Thread Starter
Forum
Replies
Last Post
carisamfreak
General Discussion
3
02-27-2009 05:59 AM
sohcpwr
Turbo Parts For Sale
5
02-06-2006 05:50 PM
HMTguy
General Discussion
8
11-14-2005 07:48 PM
Devil Motor Sports
Hybrid/Tech
8
10-19-2003 11:06 AM