General Discussion Off-Topic Discussion and Enlightenment

600 miles... is it ready for boost???

Thread Tools
 
Search this Thread
 
Old 09-05-2004, 01:16 PM
  #1  
0.0 BAR
Thread Starter
 
traff1c's Avatar
 
Join Date: Dec 2002
Posts: 0
Default 600 miles... is it ready for boost???

Well last week i finally got my new engine up and running, and i only got to put 100 miles on it... and I've been itching for boost again, so last night i went out for a drive and put 500 miles on it. so now it has 600 miles. Is it considered broken in yet? or should i slap the turbo kit on and let it slowly have a taste of boost?

Or did this engines nuts already drop and its ready to kick some *** now

traff1c is offline  
Old 09-05-2004, 01:20 PM
  #2  
3.0 BAR
 
Dr.Boost's Avatar
 
Join Date: Mar 2003
Posts: 21,479
Default Re:600 miles... is it ready for boost???

IMO, it's ready for an *** beating. Change the oil and rip it up. I'm sure some people will disagree and tell you to run it for 50,000 miles N/A and keep it under 1500rpm, but that's my opinion.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Dr.Boost is offline  
Old 09-05-2004, 01:24 PM
  #3  
3.0 BAR
 
Honda16hb's Avatar
 
Join Date: Jan 2003
Posts: 7,082
Default Re:600 miles... is it ready for boost???

what's left to break it? at this point your rings are seated, your seals have seen a few heat cycles, I don't know why people wait 200,000 miles on new engines. my favorite part is when people get jdm engine swaps and they think they have to break them in, like they weren't driven in japan, or they were rebuilt on the boat over to america.
Honda16hb is offline  
Old 09-05-2004, 01:25 PM
  #4  
3.0 BAR
 
hotrex's Avatar
 
Join Date: Dec 2002
Posts: 12,568
Default Re:600 miles... is it ready for boost???

i ran my car for 26 miles before i turboed it and my compression is 190 aross the board after 6000 miles of 10 psi abuse
hotrex is offline  
Old 09-05-2004, 01:26 PM
  #5  
3.0 BAR
 
Honda16hb's Avatar
 
Join Date: Jan 2003
Posts: 7,082
Default Re:600 miles... is it ready for boost???

wow, 10psi for 300hp, you and phiz must be champion tuners.
Honda16hb is offline  
Old 09-05-2004, 01:29 PM
  #6  
3.0 BAR
 
hotrex's Avatar
 
Join Date: Dec 2002
Posts: 12,568
Default Re:600 miles... is it ready for boost???

nah the 300 will come next week. i finally have time to wire my 3 bar and hit my 18 psi....i was just drivin it to work all summer
hotrex is offline  
Old 09-05-2004, 01:33 PM
  #7  
0.0 BAR
Thread Starter
 
traff1c's Avatar
 
Join Date: Dec 2002
Posts: 0
Default Re:600 miles... is it ready for boost???

well i ask this cause my worst fear would be to spin a bearing, but i guess everything should be fine... im gonna slap the turbo back on and change the oil, do you guys open up your old filter and check inside
traff1c is offline  
Old 09-05-2004, 01:58 PM
  #8  
con
0.0 BAR
 
con's Avatar
 
Join Date: Nov 2003
Posts: 0
Default Re:600 miles... is it ready for boost???

Factory turbo engines arn't broke in then turboed Put the boost to the ******. Every engine I built was warmed up shut off, warmed up shut off. Drove around to check for bugs, Shut off. Then RAPED for life. I never have problems with them
con is offline  
Old 09-05-2004, 02:00 PM
  #9  
3.0 BAR
 
juli0_bustamante's Avatar
 
Join Date: May 2003
Posts: 5,380
Default Re:600 miles... is it ready for boost???

no...

but i would boost already if i were you...
juli0_bustamante is offline  
Old 09-05-2004, 02:32 PM
  #10  
3.0 BAR
 
Honda16hb's Avatar
 
Join Date: Jan 2003
Posts: 7,082
Default Re:600 miles... is it ready for boost???

worried about spinning a bearing? you think it takes your oil 2000 miles to find it's way inside the bearings?
Honda16hb is offline  


Quick Reply: 600 miles... is it ready for boost???



All times are GMT -5. The time now is 08:35 AM.