Turbo 1.6 Aveo setup questions
#1
Turbo 1.6 Aveo setup questions
Hi fellas, I have started to aquire all of the parts to boost my Aveo. Please don't laugh and make jokes, I'm not dumb, I understand my car is a Daewoo. I have built the bottom end a little, had the head shaved 20 thousandths. I am not some teenager who is boosting mommy's car. I have been researching for over a year about what my options are. I am aware my fuel system is returnless so I will be completely re doing it with a 255 lph pump and injectors off a 3.4. I will be running a return line as well. I have a Audi KO4 turbo with a internal wastegate, which I want to figure out how to set at 7 psi which is plenty for my 1.6. I will be running a remote oil filter adapter for the oil supply, still researching cooling options. I am doing a top mount intercooler. Also will be getting a fuel pressure regulator. Anyway my problem is finding tuning options, I'm in the Detroit area and have called around, no one can tune it for me. How crappy are these standalone and piggyback setups. The ecu is a Delco unit. Can anyone help with anything I may be overlooking and help with the tuning, and obviously cost is a concern. Only been getting parts every once in a while and been fabricating my manifold and exhaust. Thanks guys!
#2
No joke bro, I turboe'd a Matiz so if I did that you should be good to go with a 1.6
I'd recommend speaking with Matt Cramer here on the forum to spec out a MS standalone for you. I'm about to go that way myself once all fabrication for stage 2 is done as the Piggyback I run started acting out a lot.
I'd recommend speaking with Matt Cramer here on the forum to spec out a MS standalone for you. I'm about to go that way myself once all fabrication for stage 2 is done as the Piggyback I run started acting out a lot.
#3
No joke bro, I turboe'd a Matiz so if I did that you should be good to go with a 1.6
I'd recommend speaking with Matt Cramer here on the forum to spec out a MS standalone for you. I'm about to go that way myself once all fabrication for stage 2 is done as the Piggyback I run started acting out a lot.
I'd recommend speaking with Matt Cramer here on the forum to spec out a MS standalone for you. I'm about to go that way myself once all fabrication for stage 2 is done as the Piggyback I run started acting out a lot.
Thanks a lot Brother, I'm kinda new to this forum how would I try to reach him?
Thread
Thread Starter
Forum
Replies
Last Post