extreme turbo modification help
#1
extreme turbo modification help
ok so i have a holset h1c and a holset h2d that i am going to try and make a nice hybrid turbo out of the two
what im going to try and do is machine the exhaust wheel and chra (from h2d) to except my 12cm housing off the h1c
mostly what i want to know is how should i go about machining the turbine wheel (im thinking a lathe is my best option that way all the fins would still be the same and balanced but im not sure how the fins will do on a lathe) what do you guys think would be the best option for the machining the wheel
what im going to try and do is machine the exhaust wheel and chra (from h2d) to except my 12cm housing off the h1c
mostly what i want to know is how should i go about machining the turbine wheel (im thinking a lathe is my best option that way all the fins would still be the same and balanced but im not sure how the fins will do on a lathe) what do you guys think would be the best option for the machining the wheel
#3
without expensive balancing, machining and hardening equipment building your own turbo is not an option. a lathe will not be able to machine the turbine wheel fins. u will most likely need a cnc milling machine for that. but before any machining can take place the heat treatment will have to be removed before and after machining. then everything balanced. its a waste of time and money. buy the turbo you want for a fraction of the cost of attempting to make this hybrid.
Thread
Thread Starter
Forum
Replies
Last Post